P50 Driver-Retriever
Home Up

 

            UPDATED  P50 Dent Ball Driver-Retriever

     "Great Job on upgrading my P50 Dent Ball Holder with the New Sleeve with Rubber Stoppers. It's Great, Thanks." 

~ Bob Saccente of Humm'n Horns in St. Pete, FL.~

     Thanks!  The P-50 is awesome!  I used it on two horns today.

~Dan Schultz, Evansville, IN~


     That P50! I look forward to that type of dentwork now.
I've never had as much control in fine tuning the work; as with that tool.
~LIONEL EMDE, Monk Music Pacifica, California~


                      

                      The New Improved P50 Dent Tamer

     Used with your N57G dent balls,  the P50 remains UNMATCHED when it comes to removing dents out of the back bow of a bell on a cornet or trumpet. You can nearly cut your time in half on those stubborn dings and not worry about getting the ball caught sideways in the bore. You will also have more energy available, because instead of relying on the inertia of just the little ball, you will have the entire weight of the P50 coupled with your ramrod action.
     This process is a lot easier on your wrists. The old snap and shake method wears thin as you add age. Please, do not hammer the tool into the horn bell!
     Note: If the dent is that deep, the opening for the retriever is likely too small anyway and you should probably solder a brass tab in the dent and use a puller (L13) to lift it up, and then take it out with dent balls and your P50.
                 

                      Cost of this tool is only $149.50 +s/h

      Key Benefits

bulletHolds the shaft perfectly centered while working
bulletProvides improved support for stroke cable
bulletWon't dent inside bell bore


         If you already have this great tool, the upgrade is only $32.50.  To see CLICK HERE!

             Ferree's Tools- "the most copied tools in the world"

[ Home ] [ Up ] Back to Top       

              
              Copyright © 2001 Ferree's Tools, Inc.
              Last modified: May 17, 2010