The Updated P50
Using your arm, your ramrod action and your
dent balls and hammer,
this tool still saves you time and money.
Held right and securely
Held wrong, energy could hurt horn.
Energy is centered in horn. Energy
off center, could break a solder brace.
Two more views
Upstroke
Down stroke
NOTE: Hand is always holding the bell, NOT off center to damage.
All the energy is being
used in the center, hand always on bell only!
Here is the ALL NEW N87A
Trombone Dent Removing Tool
Used on inside slide rail
Used on outside slide rail
DO NOT squeeze on upper inside slide where the venturii is underneath.
OK?
Of course, the proper fitting N53 Trombone Slide Mandrel is inside the tube!
Here are the NEW Z60-37
Trombone Dent Removal Rollers
Set up this way you have approx. 270 degrees of usage and
when turned over you'll have the overlap you wanted.
But,
remember not to use to much pressure, just take out the dent.
The Best Thing about both of these new trombone tools, is that you DON't have to BEND the slide
(and therefore, the trombone mandrels) to remove the dents, and you can
roll an ovaled slide back to round. Your trombone mandrels will stay
straight and give you better service than back when you had to replace them
every year or so. Cutting costs.
This technique also helps you do better, more precision, work.
Ferree's Tools-"the most copied tools in the world"
|
