|
Z60-37 Trombone Slide Dent Rollers
 The rollers and special Allen screw shown for inspection and as installed. 
 This way works best. Works, too, but kind of flexi, You have more than 270 degrees. and you can't SEE as well. Use these rollers in your Z60, "Equalizer"Working on the same principle as the New Trombone pliers (the N87A hand tool), this pair of rollers removes dents the same basic way, using your Z60 dent machine and the proper N52 or N53 Trombone Slide Mandrel. DO NOT USE TOO MUCH PRESSURE. No more than 1/4 to 1/2 turn of wheel AFTER solid contact is made.The Z60-37B roller goes in your Z60-14 interchangeable rod as an insert. The Z60-37A roller goes into the Z60-9A arm like your other rollers do. (Z60-28,29 &30 etc.) A shorter Allen screw is supplied to provide extra clearance. All you need to do with the Z60 is rotate the Pressure Adjustment Cylinder a quarter turn, in either direction, retighten the 4 Allen set screws and then line up the rollers. Cost of this new tool is only $99.50 +s/h SEE Z60-14 Rod Mod on Services Page or Z60-14 in this (Z60) section.
Ferree's Tools-"the most copied tools in the world" |
|
